 |
Instructions: Removing your Spring Cover |
|
|
|
Please ensure you read all the steps and thoroughly understand the instructions before you begin to remove the spring cover from your rebounder.
1) Prepare your rebounder:
Turn your rebounder upside down.
2) Fold your rebounder legs:
Turn your rebounder upside down. With the rebounder lying flat, pull each leg up and over the platform pin and lay it towards the center of the mat. Extend the leg spring only enough to allow the leg tube to slip up and over the platform pin.
3) Identify loops and bungee cords:
Your spring cover consists of six visible loop and bungee cord sections which are used to secure it around the six legs of your rebounder. Identify the loop and bungee cord of one the legs of your rebounder before you proceed.
4) Begin to remove the spring cover:
Position yourself behind one rebounder leg. With one hand to each side of the leg, curl your fingers underneath the upside down rebounder frame and grab the edge of the spring cover that is beneath it. Carefully pull the cover back towards you and then slide it over the leg to release the cover.
5) Continue to remove the spring cover:
Repeat step four with each leg of the rebounder until you have completely removed the spring cover from your rebounder.
Disclaimer: Please note that all the instructions provided on Needak.com are for informational purposes only and serve only as recommendations. Any use of these instructions or images is done at your own risk, and you defend, indemnify, and hold harmless Needak.com from any responsibility towards damages caused to you or any third parties as a result of your viewing or use of the information found on these pages. It is recommended you take all necessary precautions and familiarize yourself with the task you are attempting independent of the instructions on these pages. |
|
|
|
| |
|
